| 安装玻璃前，将裁口内的污垢清除干净 |
| 添加时间：2023/8/23 16:21:57 浏览次数： |
| 安装玻璃前，将裁口内的污垢清除干净，并沿裁口的全长均匀抹1~3mm厚的底油灰。 3.1 before installing the glass, remove the dirt from the cutting edge and evenly spread the bottom of the cutting edge between 1 ~ 3mm thick. 3.2 安装长边大于1.5m或短边大于1m的玻璃，用橡胶垫并用压条和螺钉镶嵌固定。 3.2 the installation length is larger than 1.5 m or shorter than 1m glass, with rubber pad and fastening and screw setting. 3.3 安装于竖框中的玻璃，应搁置在两块相同的定位垫块上，搁置点离玻璃垂直边缘的距离宜为玻璃宽度的1/4，且不宜小于150mm。 3.3 the glass installed in the vertical frame should be put on the two identical positioning blocks. The distance between the vertical edge of the glass and the vertical edge of the glass should be 1/4 of the width of the glass, and should not be less than 150mm. 3.4 安装于扇中的玻璃，应按开启方向确定其定位垫块的位置。定位垫块的宽度应大于所支撑的玻璃件的厚度，长度不宜小于25mm，并应符合设计要求。 3.4 the glass installed in the fan shall be positioned in the direction of the opening. The width of the positioning pad should be greater than the thickness of the supported glass. The length should not be less than 25mm and should meet the design requirements. 3.5 玻璃安装就位后，其边缘型槽模具 一次性止血带 保定水处理设备 一次性止血带 保定空压机 北京真空泵不得和框、扇及其连接件相接触，所留间隙应为2~3mm。 When the glass is installed in place, its edge shall not be in contact with the frame, fan and its connecting parts. The clearance shall be 2 ~ 3mm. 3.6 玻璃安装时所使用的各种材料均不得影响泄水系统的通畅。 3.6 the various materials used in the installation of glass shall not affect the smooth flow of the drainage system. 3.7 玻璃镶入框、扇内，填塞填充材料、镶压线条时，应使玻璃周边受力均匀。 3.7 glass insert box, fan inside, fill the filling material, insert pressure line, should make the glass periphery force is even. |
| 上一页 断桥铝门窗防渗漏要求 |
| 下一页 铝合金门窗的性能 |
Copyright © 技术支持：遨游网络